After attending this course you will be able to use program macros and use them in different scenarios For optimal results we advise you to follow this course with a working UNii and a card reader. In this way you will be able to follow the steps of the course and try it out on your own system. If you click on Course material in the bar above, you will see the requirements for this course.
For whom is this course intended?
This course is written for everyone who installs the UNii. It is a basic training and therefore particularly suitable for mechanics, engineers or work preparers. To start this course, the course UNii - Introduction must be completed.
Operation
The course consists of 5 lessons. The course takes about 90 minutes. Many lessons are provided with a video explaining the subject. The videos can be paused in between. It is also possible to adjust the volume in the video player using the slider at the bottom left of the player:
Often the accompanying documents can be consulted in the lesson material itself.
Each lesson can be completed by pressing the corresponding button. This gives you an overview of the progress.
It is always possible to look back at a lesson. This can also be useful later if you have questions or receive questions from a client.
This course ends with a test. This allows you to test whether you have understood all the information correctly. If the results are satisfactory, you will receive a certificate online.
Content of this course:
For following this course, we recommend using a configuration with the following components:
The UNii must be directly connected via IP to the PC/Laptop or the same network